Speaker Removal / Replacement

Speaker Removal / Replacement

Here are the step by step directions on how to remove the speakers:

  1. Please go to the very top of the sauna And remove the dust cover (towards the back) which will expose the electrical.
  2. You will see both speakers and the connections that run to the power supply (big red box). You will see that on the speaker, the connection is not a plug or connector, but a wire that slides onto the metal part of the speaker. Slide the connections off the speaker and ensure there is nothing connected to the speaker before moving on to the next step.
  3. On the inside of the sauna, you will see that there is a plate that is screwed into the top panel that holds the speakers in place. Go ahead and unscrew the plate and the speaker should slide out downward.
  4. Once the plate is unscrewed and the speakers are out of the lumber, you can remove or replace with new speakers provided by Finnmark Designs / Influence Sauna.
Repeat the steps backwards to successfully install the new speakers. 

    • Related Articles

    • Temperature Sensor Removal / Replacement

      Please follow the video below on how to remove or replace your temperature sensor.

    • Heater Replacement

      To replace a heater, please follow these steps: Unplug the sauna from the wall for safety Use a Philips screwdriver to begin dismounting the required heaters Please be careful when doing so as to not lose screws or heater parts Unplug the heater ...

    • Bluetooth Connection / Speaker Popping issue

      For the bluetooth, please give the sauna a "Hard Reset", which means unplugging your sauna from the wall for 10-15 minutes. When that is done, please go up on the top of the sauna and expose the wiring to the speakers (you will need to unscrew the ...

    • LED Check / Replacement

      In order to properly diagnose the cause of the issue, would you please place a working bulb into the non-working harness. This will test if the bulb needs replacement, or the harness itself. Also, please double check the connections on top of the ...

    • Control Panel Check/Replacement

      Please follow the steps in this lock/unlock video before you begin troubleshooting: Unplug the sauna before starting this process. 1. Disconnect the controller from the power supply. There are 2-3 total connections to disconnect. The round data ...