Lighting Connections Check

Remove the large dust cover. You will need a screw diver. When it is removed the top of the sauna should look as depicted below.

Please check the connections that are circled above and make sure that the light that is not working is connected and the connections are secure. 

Please disconnect and reconnect the connection marked as "Lights" in the photo above.

• Related Articles

• Heater Connections Check

  We’ve narrowed it down to the possible mis-matching polarity between the top connections that are on the roof of the sauna and the interior corner connections. You will need to remove the (large) dust cover on top with a phillips screwdriver and ...

• LED Check / Replacement

  In order to properly diagnose the cause of the issue, would you please place a working bulb into the non-working harness. This will test if the bulb needs replacement, or the harness itself. Also, please double check the connections on top of the ...

• Control Panel Check/Replacement

  Please follow the steps in this lock/unlock video before you begin troubleshooting: Unplug the sauna before starting this process. 1. Disconnect the controller from the power supply. There are 2-3 total connections to disconnect. The round data ...

• Power Tester Instructions

  If Finnmark Designs Customer Service sent you a power tester, there are a couple of areas where we need to test to make sure the electricity is not being interrupted. Please note these down as you check for Customer Service Representative Power ...

• Should I replace my Outlet for the Sauna?

  Yes. We recommend giving your sauna a fresh outlet, commercial grade if possible (grey color). Many electricians will say that an average build grade outlet can lose up to 10% of it's amperage per year; loose wires, degrading connections. Your new ...